Home / Process Automation / Signal Transmitters, Isolators and Converters


    SSX Safety Series Isolators and Splitters

    SSX Safety Series Isolators and Splitters provide isolation and signal conversion for your SIS (Safety Instrumented System) needs. These units protect and enhance loops and also pass valuable HART® data from the field transmitter to host systems and vice-versa.

    Isolate your SIS from your Basic Process Control System or monitoring system so disconnections or failures to these secondary systems don’t affect your safety system. FMEDA (Failure Mode Effects and Diagnostic Analysis) reports are available with the required safety data to ensure that risk reduction requirements are met.

    With built-in HART pass-through technology you can rest assured that when your loops use HART transmitters that critical and valuable HART diagnostic, process, and calibration information can be read on either side of the SSX/SST. Most all other isolators block and “strip off” the HART signal.

    • exida certified IEC 61508:2010. exida has certified the SSX/SST for use in an SIS up to SIL 3 in monitor mode, where only the input circuit is part of the safety function. For single use mode, the SSX/SST is approved for use in an SIS up to SIL 2.
    • Comprehensive FMEDA certified safety data. Upon request, exida-certified FMEDA data is provided to be used by a functional safety practitioner to determine the SST’s and SSX’s applicability in specific safety-related applications.
    • Valuable HART data not lost. Both the SSX and SST pass critical HART data to asset management systems, programming devices or host systems.
    • Split signals between two locations. The 4-Wire SST takes in one signal and gives you two fully isolated outputs that can be taken to two separate receiving devices. This facilitates maintenance on either output loop without losing the signal on the other output loop.
    • RFI/EMI Protection. Standard 20V/m protection offered to protect against harmful effects of radio frequency and electromagnetic interference.
    • Transmitter excitation. The 4-wire SST is capable of providing loop power to a 2-wire transmitter that is connected to its input.
    • Loop Maintenance Zener Diode Option. Allows the SSX and SST to be removed from the loop for maintenance without interrupting your safety function.

    To learn more about the SSX Safety Series Isolators and Splitters and other Moore Industries products available at BBP, click here.

  • TURCK Interface Technology

    Sometimes, applications require more protection and Turck provides the answer with an offering of barriers and isolator technologies for both hazardous and non-hazardous applications. All models of TURCK interface technology are equipped with a two-line transflective LCD display, making it easy to read even in very bright light. The modules also incorporate a universal supply voltage and removable terminals, making them easy to install in new or existing systems. Products include safety barriers, zener barriers, signal conditioners, control cabinet monitoring and more accessories.

    Safety Barriers:

    Electrically isolate your signals with a form factor to fit your application.

    Zener Barriers:

    Limit the energy in to and out of the hazardous location.

    Signal Conditioners:

    Converts or amplifies a variety of signals.

    Control Cabinet Monitoring:

    The IM(X) 12-CCM (Cabinet Condition Monitoring) can be installed and even retrofitted in virtually any cabinet or any protective enclosure to continuously check the current protection degree offered. The DIN rail device uses a switching signal to report improperly closed doors, as well as exceedances of temperature and interior humidity, to the control system.


    Supplementary components to complete your application requirements.


    Learn more about process automation instruments available from BBP. 

    Learn more about Turck Interface Technology and other products from Turck available from BBP.